Xerox D110 User Manual - page 187
Cause and Remedy
Fault code
Cause: Detected a fatal error by the controller.
Remedy: Power on/off both the controller and the printer. If the problem persists,
contact the Customer Support Center.
127-311
Remedies are described in this section for situations in which the following messages
are displayed.
Cause and Remedy
Fault Code
Message
Cause: An error occurred.
Remedy: Turn off the power, wait until the Control Panel display
goes dark and then turn on power again. If the message persists,
record the displayed contents for (xxx-yyy). Switch off the machine
immediately, wait for the Control Panel display to go dark and
contact the Customer Support Center.
A malfunction occurred.
Power-cycle the machine.
(xxx-yyy)
Cause: An error occurred and the job completed.
Remedy: Retry operation after waiting for a period.
Completed with an error.
(xxx-yyy)
Cause: An auto-recoverable internal error occurred and the machine
restarted automatically.
Remedy: Select the Close button. The machine is operating normally
now. If the error persists, call contact the Customer Support Center.
A fault has occurred. The
machine has rebooted.
Select Close. When in
doubt, report the
malfunction to our Call
Center.
(xxx-yyy)
Machine troubleshooting
Basic troubleshooting
Check the machine status for machine troubleshooting.
15-31
Xerox
®
D95/D110/D125 Copier/Printer
User Guide
Problem solving
(continued)