Xerox DocuColor 3535 Quick Start Manual - page 9
9
Preparing to print
Preparing client workstations for printing
Before you can print to the Fiery, you must install the appropriate Fiery software from
the User Software CD and connect the client to the Fiery over the network. The
software provided on the User Software CD is described in the
.
N
OTE
:
The steps for setting up printing vary slightly for Windows and
Mac OS computers.
Windows computers
For all Windows operating systems supported, the minimum steps for setting up
printing are as follows:
• Install the printer drivers and corresponding printer driver files.
• Configure installable print options.
• Configure the print connection between the client and the Fiery.
For details, see the
User Software Installation Guide
. This manual also contains
instructions for the following:
• Installing Fiery utilities
• Configuring the connection for Fiery utilities
• Copying additional files from the User Software CD, as required
Mac OS computers
To set up printing on a Mac OS computer, perform the following steps:
• Install the printer driver and PPD files.
• Set up the Fiery in the Chooser.
• Configure installable print options.