Xerox Fiery EX12 Color server Configuration Manual - page 114
5
5-8
Setting up the Fiery from a Windows Computer
Ethernet (Port Setup)
Enable Ethernet
—Select if the Fiery is to be connected to an Ethernet network.
Transmission Speed
—Chose Auto Detect if your network environment is mixed, or
choose the speed of the network to which the Fiery is attached (10 Mbps or 100
Mbps).
Token Ring (Port Setup)
Enable Token Ring
—Select if the Fiery is connected to a Token Ring network.
Maximum Frame Size
—Choose the maximum frame size recommended by the
network administrator at your site. If you are uncertain of the setting to use, select the
default value (4202).
Transmission Speed
—choose Auto Sense if your network environment is mixed, or
choose the speed of the network to which the Fiery is attached (4 Mbps or 16 Mbps).
Enable Source Routing
—Select if your network supports source routing.
Request All Routes
—This option is active only if you select enable Source Routing.
Specify whether you want the Request packet to travel to its destination by all routes.
Respond All Routes
—This option is available only if the previous option is cleared.
Select if you want the Response packet to return by all routes to the originating
computer.