Xerox Fiery EX12 Color server Configuration Manual - page 179
B
B-1
Troubleshooting
This chapter provides troubleshooting tips.
Troubleshooting the Fiery
Startup diagnostics are described in the
Installation and Service Guide
for service
technicians. Contact your authorized service/support center if you see any startup error
messages on Command WorkStation or if the Fiery does not reach the Idle state.
Troubleshooting during Setup from the Control Panel
The following section explains some error and alert messages you may see during Setup
that might not be self-explanatory.
Network Setup messages
After this Setup screen
This message
Means
Enable AppleTalk
(Network Setup>Protocol
Setup>AppleTalk Setup)
No AppleTalk zone found.
The Ethernet network cable is not attached to the
connector on the Fiery, or the network cable is not plugged
into the hub or network. If your AppleTalk network has
zones, and you want to specify a zone for the Fiery, you
must connect the network cable to the Fiery before
performing AppleTalk Setup.
This could also indicate that the AppleTalk network does
not have zones. Zones are not required for printing to the
Fiery. Press OK to continue.
Protocol Setup or Service
Setup (Network Setup)
You must first enable
a network port.
Enable at least one network port (Ethernet or Token Ring)
in Port Setup before beginning Protocol Setup or Service
Setup.
Appendix B:
Troubleshooting