Xerox Fiery EX12 Color server Configuration Manual - page 180
B
B-2
Troubleshooting
Frame Type selection
(Network Setup>Protocol
Setup>IPX/SPX Setup)
Invalid frame size.
The network hub is not connected to a Novell machine
when the Fiery tries to bind.
Warning! IPX network
number is zero.
No other IPX machine can be found on the network, or
the network hub is not connected to the network when the
Fiery tries to bind. When this occurs, the network number
defaults to zero.
Can’t detect Token Ring
hardware.
Token Ring hardware
not installed or
not functioning.
Fiery queries the Token Ring hardware. Error indicates that
some components are not installed, are not installed
correctly, or not installed in the correct device. An
unsupported Token Ring board may be in use. Check with
your authorized service/support center.
Token Ring Setup
Can’t autodetect the ring
speed. No device on ring.
The Fiery is trying to detect the current ring speed, but it is
the only machine on the Token Ring network. Connect
another machine to the Token Ring network first, before
connecting the Fiery.
Enable NDS
(Network Setup>Service
Setup >PServer Setup > NDS
Setup)
No NDS trees found.
No NDS trees were found on the Novell network. Check
to see that the frame types on the Fiery are properly
configured.
Select NDS Tree
(Network Setup>Service
Setup>PServer Setup >
NDS Setup)
Warning! Selecting a new
NDS tree deletes Bindery
setup.
You have previously connected the Fiery to a different
NDS tree. NetWise supports only a single NDS tree
connection. To avoid a potential conflict with an existing
tree connection (for example, if the connection was made
through a NetWare 4.x server in emulation mode), all
bindery settings will be deleted.
If you choose OK, and choose Yes in the following message
(Delete Bindery setup and continue?), bindery settings are
deleted and have to be re-entered in Bindery Setup.
To avoid deleting the bindery settings, press the Menu key,
or select OK and choose No in the following message
(Delete Bindery setup and continue?).
Repeat NDS Setup without changing the NDS tree, or exit
to Bindery Setup to review your current bindery settings.
After this Setup screen
This message
Means