Xerox Fiery EX12 Color server Configuration Manual - page 22
Other manuals for Fiery EX12 Color server:
Color Manual, Installation Manual, Printing Manual, Job Management Manual, Getting Started Manual
of
200
1
1-10
Connecting to the Network
Connecting network cable to the Fiery
In this section, the back panel of the Fiery is illustrated, followed by information for
connecting to the Ethernet board. For information about connecting to a Token Ring
network, see
Shut down the Fiery
before attaching it to any network device. If the Fiery has just
finished processing, wait five seconds after the system reaches the Idle state before using
the power switch to turn it off. For the proper shutdown procedure, see
Back view of the Fiery
!
10/100BaseT Ethernet (RJ-45)
Token Ring
Dongle