Xerox M123 - WorkCentre B/W Laser Reference Manual

WorkCentre M128/M123 Reference Guide 

Page 

1

dc05cc0364 

Xerox DocuColor 

Accessing Extended 

Features 

Overview 

This document enables you to access the extended features of the WorkCentre 

M128/M123 in environments where Xerox does not provide a custom driver.   

NOTE:

 Some of the commands and syntax used in this documents requires 

familiarity with either PostScript (PS) or Printer Command Language (PCL). 

This document provides the Printer Description Language (PDL) commands 

and syntax for each feature. The following items are also included: 

• 

A PostScript tables that describes the PostScript features the WorkCentre 

supports and the syntax to use the feature. 

• 

A PCL table that describes the PCL features the WorkCentre supports and 

the syntax to use the feature. 

This document is not intended to be a complete PS or PCL reference manual: it 

is a guide for using the PS and PCL commands with WorkCentre. Refer to 

these additional reference materials: PostScript Language Reference Manual, 

Third Edition, ISBN 0-201-38922-8, PCL5 Printer Language Technical 

Reference Manual Hewlett-Packard manual and Printer Job Language 

Technical Reference Manual, Hewlett-Packard manual. 

Using this Guide 

1.  Search the Feature Table to determine whether the feature you wish to use 

is supported. 

2.  Verify that the feature is supported by the platform. For example, the 

WorkCentre must have the Finisher option installed to use stapling 

commands. 

3.  Following across the table to find the syntax listed for the PDL examples 

shown. Read the Dependencies/Caveats section. 

Xerox WorkCentre

PDL Reference Guide for the 

WorkCentre M128/M123 

October 20, 2004

dc05cc0364