Xerox Phaser 3425 Service Manual - Nic Board (Pl 9.1.41)
of
180
Service Parts Disassembly
8-17
4.
Using a small flat blade screwdriver, pry outward to release the retainers (6) that
secure the interlock switch cap, and pull the cap free of the cover.
5.
Remove the Cover Open Interlock Switch
NIC Board (PL 9.1.41)
1.
Remove the Right Cover Assembly (page 8-7).
Caution
Observe proper ESD procedures when removing or replacing any circuit
boards in the printer. Refer to "General Notes on Disassembly" on page 8-3.
2.
Remove 2 thumbscrews securing the NIC Board to the rear edge of the Main
Board mounting bracket.
3.
Pull up on the front edge of the NIC Board to remove it from the connector
(CN 9) on the Main Board and remove the NIC Board to the right.
1.
Interlock Switch
2.
Switch Cap
1
2
-