Xerox WorkCentre 7300 Series Administrator's Manual - page 37
25
Microsoft (NetBIOS over IP) Networks
Before You Start
1.
Print a Configuration Report as stated in the Network Connectivity section of this guide.
2.
Referring to the report, verify that SMB is enabled. To enable SMB at the Device, if required, follow
the procedure below.
3.
Referring to the Configuration Report, verify that DNS is enabled. The use of Naming Servers is
REQUIRED to resolve NetBIOS device names to IP addresses for packet routing over the TCP/IP
network.
4.
To enable the Device to communicate with the Naming Servers, refer to the instructions supplied in the
topic "TCP/IP Dynamic Addressing", located in the NOS Selection section of this guide.
5.
When using WINS or DNS, be sure to refer to your Server Operating System documentation for the
appropriate procedure to use to enable NetBIOS name to IP address resolution on the Server.
Enabling the SMB Setting at the Device, if required
1.
Press the Log In / Out button on the Control Panel.
2.
Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3.
Press Enter on the touch screen.
4.
Press the Machine Status button on the Control Panel.
5.
Press the Tools tab.
6.
Press Connectivity & Network Setup.
7.
Press Port Settings.
8.
When the Port Settings menu displays, press the SMB selection line.
9.
Press the Change Settings button in the lower right corner of the Port Settings menu screen.
10. When the SMB selection menu displays, note that you have only one setting available on a single,
numbered horizontal line. Press this selection line.
11. Press the Change Settings button.
12. On the SMB Port Status screen, note which of the two buttons is highlighted as the current setting for
SMB Enablement. The available settings are Enabled or Disabled. To enable SMB at the device,
select the Enabled setting.
13. Press the Save button on the touch screen, which returns you to the SMB selection menu. (To exit the
screen, without making changes, press the Cancel button.)
14. Exit the SMB selection menu and return to the Port Settings menu by pressing the rectangular Close
button in the upper right corner of the touch screen.
15. Exit the Port Settings menu by pressing the rectangular Close button in the upper right corner of the
Port Settings menu screen.
16. To exit the Tools tab screen, wait several seconds for the Auto Clear service to log you out.