Xerox WorkCentre 7300 Series Administrator's Manual - page 60
48
3.
To enable a digital certificate (if needed):
a.
Click the [Properties] tab.
b.
Click the [Security] folder, then the [Machine Digital Certificate Management] link.
c.
Click the [Create New Self Signed Certificate] button.
The Machine Digital Certificate Management page refreshes and displays the Self -Signed
Certificate area.
d.
In the the Self -Signed Certificate area, click [Apply].
4.
To enable SSL:
a.
Click the [Properties] tab.
b.
Click the [Security] folder, then the [SSL/TLS Settings] link.
c.
If prompted, type or enter your System Administrator user name and password.
•
user name (default): 11111
•
password ( default): x-admin
d.
In the SSL/TLS Settings area, on the HTTP - SSL / TLS Communication line, click [Enabled].
e.
Click [Apply].
f.
If changes were made to the SSL settings you may need to:
•
Reboot the system.
•
Close and reopen the client browser.
5.
To enable the ports:
a.
Click the [Properties] tab.
b.
Click the [Connectivity] folder, then Port Settings.
c.
On the SNMP line, click [Enabled].
d.
On the SMB line, click [Enabled].
e.
On the FTP Client line, click [Enabled].
f.
On the SOAP line, click [Enabled].
g.
Click [Apply].
If changes were made to the SSL settings you may need to reboot the system.
6.
To ensure that IPv4 is enabled by default:
a.
Click the [Properties] tab.
b.
Click the [Connectivity] folder, then the [Protocols] folder.
c.
In the [Protocols] folder, click [TCP/IP].
d.
In the IP Mode area, on the IP Mode line, click or verify IPv4.
e.
If you clicked IPv4, click [Apply].
EIP applications can now register to the device.
f.
You may need to map buttons to Custom Services at the Local User Interface in order to see the
new applications.