Yamaha VL-1 Feature Reference - ● Input Gain
116
Feature Reference
●
Edit Mode
● Input Gain
≤
0 … 127.
Adjusts the level of the input signal to the dynamic filter stage. The higher the value
the higher the input level.
● Balance
≤
-64 … 63.
Sets the balance between the “wet” (the output of the dynamic filter) and “dry”
(direct) signals. The higher the value the more “wet” the signal, and therefore the more
pronounced the dynamic filter effect.
● Cutoff Tracking
≤
Fixed, KeyTrack.
Determines whether the dynamic filter cutoff frequency is fixed or tracks the
keyboard.
● Cutoff Freq.
≤
26.9 Hz … 11.9 kHz (when “Fixed”).
≤
-4.00oct … 3.94oct (when “KeyTrack”).
When the “
Cutoff Tracking
” parameter is set to “
Fixed
”, this parameter sets
the dynamic filter cutoff frequency to a specific frequency between 26.9 hertz and 11.9
kilohertz. When “
Cutoff Tracking
” is set to “
KeyTrack
”, however, this parameter
determines how much the cutoff frequency is offset from the frequency of the key played
in octave units. In the latter case negative values offset the cutoff frequency below the
frequency of the key played, while positive values offset the cutoff frequency above that
of the key played.
● Resonance
≤
1.00 … 15.67.
This parameter produces a “peaking” effect at the filter’s cutoff frequency, further
emphasizing the frequencies at that point. This higher the value the higher the resonant
peak.
The dynamic filter is fixed at the frequency specified by the “
Cutoff
Freq.
” parameter, below.
The cutoff frequency of the dynamic filter tracks the note(s) played on
the keyboard, offset by the amount specified by the “
Cutoff Freq.
”
parameter, below.
Fixed
KeyTrack