Yamaha VL-1 Feature Reference - 12: Harmonic Enhancer
78
Feature Reference
●
Edit Mode
site effect: the sound changes dramatically at low controller values while higher values
produce relatively little effect. The “
Curve
” setting is reflected in the graph to the right
of the parameters — the horizontal axis represents the controller value and the vertical
axis represents filter cutoff frequency.
•
No dynamic filter frequency variation can be applied via any controller if the
ELEMENT MODIFIER Dynamic Filter page “
Balance
” parameter is set to
“
-64
” (
≥
Page 116).
12: Harmonic Enhancer
•
The § and ¶ buttons (“
Bpag
” and “
Fpag
”) can be used to go directly
backward or forward to the next Element Controller page without having to
return to the directory.
•
The • button (“
Para
”) can be used to go directly to the Harmonic En-
hancer parameter page (
≥
Page 107), also available from the ELEMENT
MODIFIER directory. You can then return to the controller Harmonic En-
hancer page by pressing • (“
Ctrl
”) again.
● Controller
≤
off, Modulation Wheel … Touch EG (124 settings).
The Harmonic Enhancer can vary the harmonic structure of the sound over a wide
range. The “
Controller
” parameter specifies the controller to be used for harmonic
enhancer depth (wet/dry balance) control. When set to “
off
” no harmonic enhancer
depth variation can be applied via a controller.
● Depth
≤
-127 … 127.
Sets the amount of variation produced by the controller assigned to the harmonic
enhancer. The higher the value the greater the variation. Positive values cause an increase
in harmonic enhancer depth in response to higher controller values (e.g. increased breath
pressure or higher modulation wheel position), while minus values cause a decrease in
harmonic enhancer depth in response to higher controller values. The “
Depth
” setting is
reflected in the graph to the right of the parameters — the horizontal axis represents the
controller value and the vertical axis represents harmonic enhancer depth depth.