Yamaha VL-1 Feature Reference - ● Lpf
90
Feature Reference
●
Edit Mode
2-3: Breath Noise LPF Key Scalling
Breath noise LPF key scaling produces natural breath noise tone variations across
the range of the keyboard by allowing different cutoff frequency offset values to be
applied to each of two breakpoints set at appropriate keys.
•
The § button (“
Bpag
”) can be used to go directly back to the next breath
noise key scaling page without having to return to the main parameter page.
● LPF
≤
31.1 Hz … 24.0 kHz.
The “
LPF
” parameter is linked to the main breath noise “
LPF Cutoff Frq
”
parameter, and sets the cutoff frequency of the breath noise low-pass filter. Noise compo-
nents above the specified frequency are cut off. This value also determines the main
cutoff frequency on which all key-scaled variations are based (indicated by a dotted line
on the graph).
● Breakpoint 1 & 2 Key
≤
C-2 … G8.
Allows two separate key scaling breakpoints to be set at any notes between C-2 and
G8. You can position the cursor at the appropriate breakpoint key parameter and use any
of the normal data entry procedures, or use the keyboard. To use the keyboard for break-
point entry, position the cursor at the appropriate breakpoint key parameter, press the •
button (“
Kbd
”), and then press the key at which you want to set the breakpoint while
“
Kbd
” appears in inverse characters.
No breakpoint can be set to a key lower than the breakpoint to its left.
● Breakpoint 1 & 2 Offset
≤
-64 … 63.
Set the amount of cutoff frequency offset for each of the breakpoints defined by the
breakpoint key parameters, above. Negative values lower the cutoff frequency, and
positive values raise the cutoff frequency at the corresponding breakpoint. No matter
what offset value is chosen, the actual cutoff frequency will never exceed its minimum or
maximum absolute value. When different offset values are applied to adjacent break-
points, the cutoff frequency varies smoothly between the breakpoints.