Zebra MtP400 Operator's Manual - page 30

Printer Configuration 

IrDA Interface 

INTERFACE MENU 

IrDA

Note that “IrDA” must be displayed on the bottom line of the display in order to access the following features 

and for this interface to be active when Setup is exited. 

Emulation 

Emulation 

Printek

Possible Values:  Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump 

This feature sets the family of printer commands that may be used by a host application program to control the 

various capabilities of the printer.  The printer will only respond to commands valid for the currently selected 

emulation.  For more information, please refer to the MtP400 Series Programmer’s Manual. 

Bluetooth Interface 

INTERFACE MENU 

Bluetooth

Note that “Bluetooth” must be displayed on the bottom line of the display in order to access the following 

features and for this interface to be active when Setup is exited. 

Emulation 

Emulation 

Printek

Possible Values:  Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump 

This feature sets the family of printer commands that may be used by a host application program to control the 

various capabilities of the printer.  The printer will only respond to commands valid for the currently selected 

emulation.  For more information, please refer to the MtP400 Series Programmer’s Manual. 

Note: After pressing the   Enter Button to move from Emulation to Pairing Mode, the printer will pause 

and display “Waiting for Bluetooth” while reading the current configuration from the Bluetooth 

interface module. 

24