Zebra MtP400 Operator's Manual - page 32

Printer Configuration 

Address 

Address 

0080371B8F32

Possible Values:  Twelve digit hexadecimal string. 

This feature displays the unique hardware value associated with the particular Bluetooth interface installed in 

the printer.  This value is set by the hardware manufacturer, is guaranteed to be unique for each interface, and 

may not be changed. 

Wi-Fi Interface 

INTERFACE MENU 

Wi-Fi

Note that “Wi-Fi” must be displayed on the bottom line of the display in order to access the following features 

and for this interface to be active when Setup is exited. 

Emulation 

Emulation 

Printek

Possible Values:  Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump 

This feature sets the family of printer commands that may be used by a host application program to control the 

various capabilities of the printer.  The printer will only respond to commands valid for the currently selected 

emulation.  For more information, please refer to the MtP400 Series Programmer’s Manual. 

Note: After pressing the   Enter Button to move from Emulation to WLAN Type, the printer will pause 

and display “Waiting for Wi-Fi” while reading the current configuration from the Bluetooth interface 

module. 

WLAN Type 

WLAN Type 

Infrastructure

Possible Values:  Infrastructure*, Peer-to-Peer 

This feature specifies the type of wireless network the printer will be attached to.  An Infrastructure network 

consists of nodes that connect to each other and/or a wired network through an Access Point.  A Peer-to-Peer , 

or Ad-Hoc, network consists of nodes that connect directly to each other without the control of an access point. 

26