Zebra MtP400 Operator's Manual - page 33

Printer Configuration 

WLAN Channel 

WLAN Channel 

1

Possible Values:  1* … 14 

Note that this feature is only available if the WLAN Type is set to Peer-to-Peer. 

This feature sets the radio channel to be used when communicating in a Peer-to-Peer network.  When in an 

Infrastructure network, the radio channel is automatically assigned by the interface and Access Point. 

WLAN SSID 

WLAN SSID 

any

Possible Values:  any*, 

Up to 16 characters of “0” through “9”, “A” through “Z”, “a” through “z”, 

This feature specifies the “name” of the network the printer will connect to.  This allows communications to be 

controlled, or routed to the appropriate nodes when multiple wireless networks are present.  When set to “any”, 

the printer may connect to any available network(s). 

To advance through the character positions, press the   Advance Button.  To change the character at the current 

position, press the   Increment Button.  The order of characters that may be selected is “0123456789  

ABCDEFGHIJKLMNOPQRSTUVWXYZ  abcdefghijklmnopqrstuvwxyz”. 

WLAN WEP Bits 

WLAN WEP Bits 

0

Possible Values:  0*, 64, 128 

This feature specifies the level of Wired Equivalent Security to use.  If set to “0”, security is turned off.  If set to 

a“64” or “128” bit encryption level, a WEP Key must be entered that matches the key on the other nodes on the 

network. 

WEP Key 

Key1: 1234567890 

– OR – 

Key1: 0123456789 

01234567890ABCDE

Possible Values:  10 or 26 character user specified hexadecimal string 

Note that this feature is only available if WLAN WEP Bits is set to 64 or 128. 

This feature specifies an encryption “key” or password that is used to encrypt/decrypt data on the network.  If 

WLAN WEP Bits is set to “64”, a ten character hexadecimal string must be entered that matches the key on the 

other nodes the printer will be communicating with.  If WLAN WEP Bits is set to “128”, a 26 character 

hexadecimal string must be entered. 

27