2gig Technologies GC3 User Manual - page 68
Proprietary & Confidential
10 System Settings
Figure 9
System Ready to Arm (BYPASS) Status
7.
Continue by arming the system. See "Arm the System" on page
31.
After the system is disarmed, bypassed sensors are automatically
removed from the system's Bypassed Sensors list, unless the Auto
Bypass for Manual Bypass feature is enabled.
NOTE:
Consult your installer to determine if the Auto Bypass
for Manual Bypass feature is enabled. See
"Auto Unbypass
for Manual Bypass" on page 1
.
Removing Sensors from the Bypassed Sensors List
After the system is disarmed, bypassed sensors are automatically
removed from the system's Bypassed Sensors list, unless the Auto
Bypass for Manual Bypass feature is enabled. If you decide you want
to remove a sensor from the Bypassed Sensors list before you arm the
system, use the steps detailed here.
To remove a sensor from the Bypassed Sensors list:
1.
At the Home screen, tap System Settings.
2.
Enter the Master User Code to access the System Settings.
3.
Tap Bypass Sensors.
4.
Move the slide control to the left for the desired sensor. This
removes the sensor from the system's Bypassed Sensors list.
5.
Tap t when finished.
Smart Home Settings
The Smart Home Settings menu gives you the ability to add and remove
Z-Wave devices from the network.
NOTE:
Consult your installer to determine if the Z-Wave
Feature has been enabled on your system. Some
configurations only make this feature available to the
installer.
NOTE:
This feature is PIN-protected. To use this feature,
you must know the four-digit Master User Code.
Adding a Z-Wave Device to the Network
To add a Z-Wave device to the network:
1.
At the Smart Home Settings menu, tap Add Devices.
The Listening for Devices to Add screen appears.
Figure 10
Listening for Devices to Add Screen
2.
Walk to and trigger the device to transmit.
When the system discovers a device, the system automatically
adds it and the Adding Device message appears.
Figure 11
Adding Device
3.
Tap OK at the New Device was Added to the System
message.
Figure 12
New Device was Added to the System Message
Copyright © 2015 Nortek Security & Control LLC
68