2gig Technologies GC3 User Manual - page 83
About the Smart Home Settings Menu
Installers can configure the system to give the Master User permission to
access the Smart Home Settings menu, users who know the Master
User code can access a variety of Z-Wave settings for the GC3 Security &
Automation System.
NOTE:
The GC3 Panel ignores any basic commands it
receives from other devices on the Z-Wave network.
Navigate to the Smart Home Settings Menu
To navigate to the Smart Home Settings menu:
1.
At the Home screen, tap System Settings.
Figure 1
Smart Home Settings Button
2.
At the Enter Your Code to Access the System Settings
screen, enter the system's four-digit Master User Code.
Figure 2
Enter Your Code to Access the System Settings
3.
At the System Settings menu, tap Smart Home Settings.
Figure 3
System Settings > Smart Home Settings
NOTE:
Consult your installer to determine if the
Smart Home Settings menu has been enabled on
your system. Typically, this button is grayed out and
not available because the factory default setting for
this feature is Disabled but Visible.
This reveals the Smart Home Settings menu.
Figure 4
Smart Home Settings Menu
Add a New Device
To add a Z-Wave device to the network:
1.
Navigate to the Smart Home Settings menu. See "Navigate to
the Smart Home Settings Menu" above.
2.
At the Smart Home Settings menu, tap Add Devices.
Figure 5
Smart Home Settings—Add Devices
The Listening for Devices to Add screen reveals the Add
Devices Now message.
Figure 6
Listening for Devices to Add—Add Devices Now
3.
Walk to and trigger the device on the network. For example, if you
are adding a Z-Wave light bulb, turn the light bulb ON.
11 Smart Home Settings
Proprietary & Confidential
83
Copyright © 2015 Nortek Security & Control LLC