2gig Technologies GC3 User Manual - page 87
Figure 25
View All Devices > Remove
4.
At the Force Remove Device (
Remove.
Figure 26
Force Remove Device—Remove
The system removes the device from the network.
Figure 27
Device Removed
Reset the Controller
You can reset the Z-Wave controller to remove all Z-Wave devices from
the network and to reset the controller to its factory default state.
NOTE:
Use this procedure only in the event that the network
primary controller is missing or otherwise inoperable.
To reset the controller:
1.
Navigate to the Smart Home Settings menu. See "Navigate to
the Smart Home Settings Menu" on page 83.
2.
At the Smart Home Settings menu, tap Advanced Settings.
Figure 28
Smart Home Settings—Advanced Settings
3.
At the Advanced Settings menu, tap Reset Controller.
Figure 29
Advanced Settings—Reset Controller
4.
At the Reset the Z-Wave Controller screen, tap Reset
Controller.
Figure 30
Reset the Z-Wave Controller—Reset Controller
NOTE:
Resetting the controller will delete all node
information from the GC3 Control Panel. Any
devices that were part of the mesh network will need
to be manually removed from the network before
they can be added to another network.
While the controller is being reset, the Working message
appears.
11 Smart Home Settings
Proprietary & Confidential
87
Copyright © 2015 Nortek Security & Control LLC