2gig Technologies GC3 User Manual - page 75
Figure 22
System Settings—Smart Home Settings
4.
At the Smart Home Settings menu, tap Device Association.
Figure 23
Smart Home Settings—Advanced Settings
5.
At the Z-Wave Association screen, tap the Manage button
next to the device that will act as the controller.
Figure 24
Z-Wave Association—Manage
6.
Select the Group for the association.
7.
Select the devices to be associated with the controller device and
tap 3.
NOTE:
Refer to device documentation for information about
the association groups supported by the device.
The following association groups are available in the GC3 Panel:
Group 1: Lifeline
Maximum number of nodes supported: 20.
Group 2 Armed (On):
Maximum number of nodes supported:
20.
Group 3 Armed (Off):
Maximum number of nodes supported:
20.
Group 4 Disarmed (On):
Maximum number of nodes
supported: 20.
Group 5 Disarmed (Off):
Maximum number of nodes
supported: 20.
Group 6 Alarm:
Maximum number of nodes supported: 20.
Screen
Use the Screen feature to adjust the screen brightness, dim brightness,
backlight timeout, and to place the touchscreen into clean mode.
NOTE:
This feature is PIN-protected. To use this feature,
you must know the four-digit Master User Code.
Navigating to Screen
1.
At the Home screen, tap System Settings.
Figure 25
Home Screen > System Settings
2.
At the Enter Your Code to Access the System Settings
screen, enter an active, four-digit user code.
Figure 26
Enter Your Code to Access the System Settings
3.
At the System Settings menu, tap Screen.
10 System Settings
Proprietary & Confidential
75
Copyright © 2015 Nortek Security & Control LLC