3Com 3CRDSF9PWR-US - OfficeConnect Managed Fast Ethernet PoE Switch User Manual - page 96
96
C
HAPTER
4: M
ANAGING
D
EVICE
S
ECURITY
Configuring ACL
Binding
After configuring the required ACLs, you should bind them to the ports
or LAGs that need to filter traffic. You can only bind an interface to one
ACL for each basic type – IP and MAC.
The
ACL Binding Setup Page
allows the network administrator to bind
specific ports to MAC- or IP-based ACLs.
Monitor users have no access to this page.
To define ACL Binding:
1
Click
Device > ACL > ACL Binding > Setup
. The
ACL Binding Setup
Page
opens:
Figure 49
ACL Binding Setup Page
The
ACL Binding Setup Page
contains the following fields:
■
Select Port(s)
— Selects the ports to be configured.
■
Bind ACL
— Assigns an Access Control List to a port or LAG.
■
MAC-based ACL
— Displays the MAC based ACL to which the
interface is assigned.
■
IP-based ACL
— Displays the IP based ACL to which the interface is
assigned.
■
Select ACL
— Selects the ACL from a list of previously defined Access
Control Lists to which the port or LAG can be bound. To bind an ACL
to a LAG, the ACL should be bound to its port members.