3Com 5500G Configuration And Command Reference Manual - page 26
26
Chapter 3: Configuring an Application Control System Exchange Interface
■
For a description of the
osm
connect unit
command, refer to “osm
connect unit” on page 31.
■
The above
rpm
commands are Linux operating system commands and
not covered in this document.
Configuring the
Default Startup
Settings for an ACSEI
Client
The ACSEI client is enabled once it is installed, and by default, after the
Linux system starts up, it starts up the ACSEI client automatically. You can
modify the default setting using the following commands.
Modifying the default startup setting through the command line
interface (CLI)
Follow these steps to configure the ACSEI client’s default startup setting:
Modifying the default startup settings through GUI
To modify the default startup settings through the GUI, perform the
following steps:
1
Execute the
osm connect unit
command in user view to enter the
OSN|M’s Linux system.
2
Execute the
setup
command and the ACSEI GUI is displayed as shown in
Figure 4.
To... Use
the
command...
Remarks
Switch to the OSN|M’s
Linux OS from the switch’s
CLI
osm connect unit
unit-id
Required
Available in user view
After the operation, the
operating interface is
switched to the Linux
system interface where
you can execute the
following commands.
Configure the ACSEI client
to
not
start automatically
when the Linux system is
started
chkconfig acseid off
Required
By default, the ACSEI
client is started up
automatically with the
startup of the Linux
system.
Configure the ACSEI client
to start up automatically
when the Linux system is
started
chkconfig acseid on
Required
By default, ACSEI client is
started up automatically
with the startup of the
Linux system.