3Com 5500G Configuration And Command Reference Manual - page 8
8
Chapter 1: Configuring the OSN|M
Restarting the
OSN|M’s Linux OS
After you log into a switch, you can restart the OSN|M’s Linux OS of the
local switch or another switch in the same fabric if you need to
troubleshoot that system.
An OSN|M has an independent CPU. Therefore, restarting the Linux OS
does not affect the status of the switch. That is, the OSN|M and the
switch can restart independently. Restarting the Linux OS on the OSN|M
will not result in restarting the switch.
To restart to the OSN|M’s Linux system, use the
OSM reboot unit
unit-id
command. This command is available in user view.
c
CAUTION:
Restarting the Linux OS on an OSN|M may cause data loss and
service interruption. Therefore, before restarting the module, make sure
to save the Linux OS data.