3Com 5500G Configuration And Command Reference Manual - page 48
48
Chapter 7: ACSEI Client Configuration Commands on the OSN|M
Parameters
None
Description
Use the
acsei-client debug enable
command to enable debugging for
the ACSEI client.
By default, debugging for the ACSEI client is disabled.
Examples
# Enable debugging for the ACSEI client on unit 1.
Connected to OSM!
[root@localhost ~]# acsei-client debug enable
acsei-client debug show
Syntax
acsei-client debug show
View
Any Linux system directory
Parameters
None
Description
Use the
acsei-client debug show
command to display the debugging
information about the ACSEI client.
By default, no ACSEI client debugging is displayed.
Note that ACSEI client debugging is displayed through a pipe; therefore,
part of the debugging information may fail to be displayed when the pipe
is full.
Examples
# Display ACSEI client debugging information on unit 1.
Connected to OSM!
[root@localhost ~]# acsei-client debug enable
[root@localhost ~]# acsei-client debug show