3Com 5500G Configuration And Command Reference Manual - page 28
28
Chapter 3: Configuring an Application Control System Exchange Interface
■
[ * ]
specifies that the Linux system automatically starts up ACSEI
client when started up.
■
[ ]
specifies that the Linux system does not start up ACSEI client when
started up.
5
Check your choice, use the
Tab
key to move the cursor to
OK
, press
Enter
. You return to the previous view.
6
Select
Quit
to exit the Setup interface.
Controlling ACSEI
Client
Follow these steps to control ACSEI client:
c
CAUTION:
■
Conditional restart means that if the ACSEI client process is running,
the command stops the process and then restarts it, and if the ACSEI
client process is not running, the command does not restart the
process.
■
Do not stop and restart the ACSEI client process repeatedly within five
seconds; otherwise, other applications may not be aware of the ACSEI
client change.
To... Use
the
command...
Remarks
Switch to the OSN|M’s
Linux system from the
switch’s CLI
osm connect unit
unit-id
Required
Available in user view
After the operation, the
operating interface is
switched to the Linux
system interface where
you can execute the
following commands.
Start up the ACSEI client
service acseid start
Optional
By default, the ACSEI
client is started up.
Load the ACSEI client
configuration file
service acseid reload
Optional
Restart the ACSEI client
service acseid restart
Optional
Restart the ACSEI client
conditionally
service acseid
condrestart
Optional
Stop the ACSEI client
service acseid stop
Optional