3Com 5500G Configuration And Command Reference Manual - 1 Configuring The Osn|M
1 Configuring the OSN|M
OSN|M Overview
You can use the Open Services Networking Module (OSN|M) as an
expansion module installed in an expansion module slot on the rear panel
of a Switch 5500G. The OSN|M runs the Linux operating system (Linux
OS) with which you can load software such as security and voice software
as needed.
You can log into the OSN|M’s Linux system through:
■
The OSN|M’s console port.
■
The OSN|M’s management Ethernet port using SSH.
■
The OSN|M’s internal service interface using SSH
■
The user interface of the Switch 5500G using serial interface
redirection.
This chapter introduces how to operate and configure an OSN|M after
you log into the OSN|M’s Linux OS using the last method. The OSN|M
configurations on the switch include:
■
“Switching to the OSN|M’s Operating Interface” on page 7
■
“Restarting the OSN|M’s Linux OS” on page 8
For an introduction to other login options, refer to
3Com Switch 5500G
OSN|M Getting Started Guide
.
Switching to the
OSN|M’s Operating
Interface
You can log into a switch through its console port or an Ethernet
interface, then connect to the switch’s OSN|M or to another switch’s
OSN|M in the same fabric. In this case, if the OSN|M’s Linux system is
running, the terminal display interface switches from the switch’s
command line interface (CLI) to the Linux OS interface. After the
switchover, you can return to the switch’s CLI using the shortcut key
Ctrl+K
.
To connect to the OSN|M’s Linux system, use the
OSM connect unit
unit-id
command. This command is available in user view.