3m™ wireless communication system, model xt-1 operating instructions rev 1.0 © 3m 2007 november :system menu 01>drivethru volume 02>monitor volume 03>night volume 06 set time & date.
Table of contents 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 3 of 48 table of contents overview ..................................................................................................................................... 7 safety in...
Table of contents 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 4 of 48 detector type ........................................................................................................................ 20 order taking modes setup ............
Table of contents 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 5 of 48 troubleshooting .................................................................................................................. 37 general troubleshooting .................
Table of contents 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 6 of 48.
Overview 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 7 of 48 overview safety information safety rules read, understand, and follow all safety information contained in these instructions prior to installation & operation of the 3m headset inte...
Overview 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 8 of 48 system warnings warning to reduce the risks associated with hazardous voltage: • disconnect power to the receptacle before installing or removing the base station power supply. When...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 9 of 48 configuration enter configuration mode configuration mode is a passcode-protected area that contains most of the configuration options for the base station system. Using the ac...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 10 of 48 buttons following is a brief description of the buttons on the display and their functions. Directional arrow ( xwts ) buttons you can use these buttons to scroll around when ...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 11 of 48 service (shift) button use the service button to access upper-case letters or to initiate a service call to 3m or as a confirmation in some items. Pressing and holding the ser...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 12 of 48 to find out your user password: 1. Enter the configuration mode (see page 9). 2. Select 13 change passcodes > change user passcodes . 3. Look at the passcode following your us...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 13 of 48 to change the vehicle alert volume: 1. Enter the configuration mode, see page 9. 2. Select a new value for 01 drivethru volume > vehicle alert volume . The range is 0 (silent)...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 14 of 48 vehicle present changing the vehicle present volume affects how loudly the monitor plays the vehicle present tone. You can also disable the monitor playing the vehicle present...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 15 of 48 2. Select 02 monitor volume . 3. To enable or disable the monitor playing greeter messages, change the value for greeter messages: enable to on or off . 4. To change the volum...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 16 of 48 remove headsets perform the following steps to un-register a lost, destroyed, or otherwise removed headset from the system, including a headset that is sent back to 3m for rep...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 17 of 48 2. Make a new selection for 05 noise reduction > inbound mic noise reduction level . Options are off , min , low , med , hi , and max . You may need to experiment for a settin...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 18 of 48 drive thru audio duplex mode the system can function using half duplex or full duplex modes. Choosing between the two modes is based upon the desired operation. Note: in half ...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 19 of 48 store is now closed prompt perform the following procedure to enable or disable the automatic store closed prompt to let customers know in your absence that the store is close...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 20 of 48 2. Change the value for 07 global settings > page messages can cross lanes? To yes or no . Detector type because there are two basic types of vehicle detector, pulse and prese...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 21 of 48 note: all timekeeping is done using a 24 hour clock (e.G., 6:00 p.M. Appears as 18:00). Regular site schedule the regular site schedule is the opening and closing times for ea...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 22 of 48 3. To enable or disable self monitoring, change the value for self monitoring enabled? To yes or no . 4. If self monitoring is enabled: • select a value for number of inactive...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 23 of 48 save installation settings note: this function is only available to installers. Perform the following procedure to save the current configuration into permanent memory over th...
Configuration 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 24 of 48 activate the backup intercom many systems include a wired backup intercom system that can be used if the main wireless system cannot be used. If your system has a backup inter...
Operation 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 25 of 48 operation headsets overview this chapter provides instructions for using headsets with an xt-1 intercom system after the system has been installed, configured, and powered on. Com...
Operation 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 26 of 48 • on/off : turns the headset on and off. Hold for 3 seconds to turn off. • volume : the up button increases volume, the down button decreases volume. • page : allows you to talk t...
Operation 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 27 of 48 out of range in addition to “change battery now” you may also hear a message for “out of range.” if you hear this in your headset, you need to move closer to the base station. You...
Operation 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 28 of 48 base station setup most of the base station configuration is performed during installation by the installer or by a manager. The setup options listed in this section are only thos...
Operation 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 29 of 48 3. Press t , s , x , or w to select a new order taker mode. Your choices are ml/ptt , ml/mlt , al/ptt , al/mlt , hands free , outside , and always on . See “explanation of order t...
Operation 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 30 of 48 in hands free , the headset microphone is on whenever the order point vehicle detector detects a vehicle. Because automatic standby (see below) is also on when hands free is on, t...
Operation 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 31 of 48 split lane split lane mode is the preferred mode for heavy volume because it essentially separates the communications between the two base stations. • operators will only hear a s...
Operation 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 32 of 48.
Maintenance 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 33 of 48 maintenance headset replacing the ear and headband pads to replace the ear pad, remove the worn/damaged ear pad from the ear cup and replace it with a new pad. To replace the he...
Maintenance 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 34 of 48 batteries care, handling and storage • avoid dropping batteries. • do not carry batteries in your pockets or leave them in hot, damp or dirty places. • clean the battery contact...
Maintenance 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 35 of 48 making sure batteries are ready for use follow these tips to make sure batteries are always ready for use: • have an extra battery for each headset. This helps ensure that a ful...
Maintenance 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 36 of 48.
Troubleshooting 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 37 of 48 troubleshooting general troubleshooting problem possible cause solution the base station has no power. Make sure the power transformer is plugged into the wall outlet and in...
Troubleshooting 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 38 of 48 problem possible cause solution defective backup intercom or wiring. Call for authorized service. Worn or defective talk or page switch. No talk or page to other headsets fr...
Appendix: base station specifications 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 39 of 48 appendix: base station specifications physical parameter specification or requirement dimensions (l x w x d) 20 in. X 11½ in. X 2 in. (51 cm x 29 cm x ...
Appendix: base station specifications 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 40 of 48.
Appendix: greeter module 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 41 of 48 appendix: greeter module greeter setup the greeter module is an accessory that stores prerecorded messages and plays them back when vehicles arrive. You can record ...
Appendix: greeter module 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 42 of 48 perform the following procedure to record (store) a new greeter message: notes: if you store a new greeter message in an occupied slot, the old greeter message will...
Appendix: greeter module 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 43 of 48 perform the following procedure to enable or disable playback through the monitor: 1. Enter the greeter configuration menu, see page 41. 2. Change the value for 3 g...
Appendix: greeter module 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 44 of 48.
Index 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 45 of 48 index acoustic echo .................................................. 17 acoustic echo cancelling................................. 17 adding headsets ...................................
3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 46 of 48 listen modes.................................................... 29 listing headsets ............................................... 16 load templates .........................................
Index 3m™ wireless communication system, model xt-1: operating instructions rev 1.0 © 3m 2007 november page 47 of 48.
Building and commercial services division food services business 3m center st. Paul, mn 55144-1000 printed in u.S.A. © 3m 2007 november 78-6911-4939-3 rev 1.0