A&D HV-200KGL-WP Instruction Manual - page 18
Page 16
HVG-WP Series
7. Basic Operation
7.1.Turning the Scale on/off and Weighing
7.1.1.
Type V or Type L with AC Adapter
Step 1 Ground the scale using the earth terminal.
Step 2 Confirm nothing is placed on the weighing pan.
Step 3 Confirm that local voltage and outlet type are correct.
Step 4 The scale turns on using the
ON/OFF
key.
Step 5 Check the accuracy of weighing. Allow 30 minutes warming up before calibration.
Step 6 With nothing on the pan, press the
ZERO
key to display zero.
Step 7 Place an article on the weighing pan gently.
Step 8 Wait for the stability mark to be displayed. Read the weight.
Step 9 Remove the article from the weighing pan.
Step 10 Turn the scale off using the
ON/OFF
key.
Memo
With the power cord connected, type V is in standby status after the scale is turned off
using the
ON/OFF
key. To shut down the power completely, disconnect the power
cord.
With the AC adapter connected, the power is off at the scale, but not from the AC
adapter, after the scale is turned off using
ON/OFF
key. To shut down the power
completely, disconnect the AC adapter.
Caution
The HVGL-WP scale should only be operated using the adapter supplied.
Failure to do this could result in damage to the rechargeble batteries and a
void of the product warranty.