A&D HV-200KGL-WP Instruction Manual - page 20
Page 18
HVG-WP Series
Tare (And Net Display)
"Tare" is used to cancel the mass of a container, receptacle, case, bag, etc. which is
put on the weighing pan to contain the item to be weighed.
Caution
Using a tare value reduces the weighing range.
The current tare value is reset by pressing the
ZERO
key or turning the scale
off. (Reset value is zero.)
The preset tare value must be within the minimum weighing range for the
HV-WP series.
7.1.3.
Manual Tare
Step 1 Put the container on the weighing pan.
Step 2 Press the
TARE
key. The display becomes zero and the net mark is displayed.
Step 3 It is now possible to put something into the container and to read its net display.
Step 4 Once weighing with tare is complete, remove all items from pan and press ZERO
key to return to true zero.
7.1.4.
Preset Tare
Step 1 Press and hold the
SET
key and press the
TARE
key.
The blank or stored tare value is displayed. A blank display means that the tare
value is zero (reset value), and or
blinks.
Step 2 Set the preset tare value by using the following keys.
∧
key
Adjusts the value of the figure.
<
key
Selects a figure.
F
key Selects the polarity (+,-).
Step 3 Press the
ENTER
key to store the new preset tare value.
Then the scale displays a net value with the tare value subtracted from the gross
weighing value.
Step 4 It is then possible to put something into the container and to read its net.
Step 5 Once weighing with tare is complete, remove all items from pan and press ZERO
key to return to true zero.