A&D HV-200KGL-WP Instruction Manual - page 23

HVG-WP Series 

Page 21 

Explanation 

  The status of "Inactive comparator (F6)" is that comparator function (F6 0, F6 2, F6 4, F6 

6) is selected and the comparator is not used. The "active" or "Inactive" (ON/OFF) for the 

comparator can be selected by pressing the  SET  key alternately. 

  The following parameters are stored in the same memory. Therefore, the functions 

can not be used at the same time. If you use each function, it will be necessary to 

reselect the function from the function table and to set the parameters of HI,OK and 

LO for each application.  

Memory address / Indicator and Output 

HI OK LO 

Upper/Lower Comparator Function (f6 0  ~ 7) Upper limit 

Lower limit 

Simple Batch Function (f6 8)  

Final value 

Preliminary 

value 

Zero band 

Full/ Dribble Batch Function (f6 9) 

Final value 

Preliminary 

value 

Zero band