Access 902 User Manual - page 10
9
To select a product from the Control Panel using the UP/DOWN arrow keys:
1. PRESS the desired Product Group button if not already SELECTED.
2. Use the UP key (▲) to select next higher numbered product in Product Group and press repeat-
edly to continue advancing.
3. Use the DOWN key (▼) to select next lower number product in currently SELECTED Product
Group.
DOUBLE-CLICK of the UP/DOWN keys will increment/decrement product selection by a factor of 10. If
UP/DOWN arrow keys are used to scroll through a speaker Product Group where multiple pairs of speakers
are ACTIVE, then the most recent speaker selection is incremented or decremented. The other ACTIVE
speakers in the Product Group are not affected.
To turn off all products in a Product Group:
This may be done by either of two ways:
1) Deselect the Product Group by DOUBLE-CLICKing its Select Key, or
2) Deselect the ACTIVE product within that GROUP by entering its number again.
In both cases the result is the same. The Product Group window will display dashes (– –), indicating that the
Group is available, but not ACTIVE.
Storing and Demonstrating Component Systems
There are three different ways to store complete systems with 902 or 903 Control Panels. During product
demonstrations, it is normal to “build” a system for your customer as you qualify his/her needs during the
selling process. Once the components of the desired system are active, the system may be stored in one of the
following ways:
1) LPRESS the A, B, or C keys. These keys are essentially used like scratchpad or “flash” memory.
Once a system has been stored in this way, PRESS A, B, or C to instantly compare the stored
systems. Future systems can be stored in A, B, or C by repeating the same process thereby over-
writing the previously stored systems.
2) LPRESS any unused Product Group Select Key to store the system that is currently playing. Once
stored, the system can be SELECTED by simply PRESSing the Product Group key. When selected,
“SY” will be displayed in the system’s Product Group window and all the components comprising
the system will have their numbers displayed in their respective Product Group windows. Future
systems can be stored in the same manner by simply overwriting with a newly selected system.
3) Store as 1 of up to 99 systems in the Systems Product Group. To do this:
• Select the Systems Product Group by PRESSing its Select Key.
(DIP Switch-C must be ON).
• Enter a 1 or 2 digit number (e.g. #22) for the system.
• LPRESS the Systems Product Group’s Select Key to store.
Continue this procedure to store up to 99 systems. Systems that have been temporarily stored using the A, B,
or C keys may be copied to the System Product Group to prevent being erased.
To select a system previously stored in the System Product Group:
1) SELECT the Systems Product Group,
2) Enter the 1 or 2 digit system number you wish to play, and
3) PRESS the Systems Product Group key or wait 2 seconds for auto-enter.
You may also use the UP/DOWN arrow keys to scroll through systems.