Access 902 User Manual - page 16
15
SECURE 5 – TheftAlert Alarm Reset
Shuts off alarm or siren after TheftAlert detects that a product has been removed without permission, and
resets TheftAlert to detect another theft.
- Secure 91 & Secure 95 must be on to use this feature.
- TheftAlert switch on the 980 system module must be in the OFF position.
To turn off Alarm, PRESS:
1) SECURE • 5 • SECURE*
SECURE 87 – TheftAlert Alarm Memory Display & Clear
Displays from memory the product numbers of any components that have triggered a TheftAlert
alarm, and allows memory contents to be cleared after being displayed.
- Secure 91 & Secure 95 must be on to use this feature.
To display or clear a Theft Alert alarm, PRESS:
1) SECURE • 8 • 7 • SECURE*
If desired, press SECURE to end flashing displays before 30 second timeout.
2) LPress SECURE to clear TheftAlert memory.
If “coA” appears in 3 character display window, enter 3-digit Code A or Code B, described in
Step 3.
3) # • # • # • SECURE*
SECURE 88 – System Hardware Reset
Provides a method for forcing a hardware reset (warm boot) for the control panel, switch modules, and 980
system module. Used after changing switching module address, control panel DIP switch settings, etc. to
store new values, as a convenient alternative to removing power from the system.
To reset system, PRESS:
1) SECURE • 8 • 8 • SECURE*
SECURE 89 – Display Software Revision Number
Causes software revision number to be displayed in the 3 character window for 2 seconds.
To display software revision number, PRESS:
1) SECURE • 8 • 9 • SECURE*
SECURE 91 – Global On/Off for Secure Commands
Provides a master on/off toggle for most secure features.
To turn Secure features ON/OFF, PRESS:
1) SECURE • 9 • 1 • SECURE*
2) Use the ▲ or ▼ keys to toggle between “ON” (features enabled) & “OFF” (features disabled)
3) SECURE*
If “coA” appears in 3 character display window, enter 3-digit Code A in Step 4.
4) # • # • # • SECURE*