Access 902 User Manual - page 9
8
leaving some vacant (i.e. no attached switching modules). If this is the case, then your 902/903 Control Panel
can be used very creatively by programming a single promotional system into each unused Product Group,
for instant one-button activation. Such a configuration might use Product Groups 4 - 7 like this:
Product Group Window
Audio Video System
1
Sources
2
Receivers
3
Speakers
4
Manager’s Special
5
$649 Installed!
6
The Latest Technology
7
Advertised Special $499
8
Systems
The last Product Group can store up to 99 preprogrammed systems of your choice if there are no components
assigned to that Product Group. To enable this feature, DIP Switch “C” on the Control Panel’s Configuration
DIP Switch array must be ON. See the diagram on page 3.
Blank and printed labels for all types of component Product Groups are included with your 902 or 903
Control Panel. However, you may wish to make your own labels using different words, symbols or lan-
guages, maybe even on different colored paper. If so, custom label inserts can be printed on 20 - 24# paper
using the following specifications:
Label size: .45” H x 2” W
Max. Text Width: 1-3/8”
Text Center: 11/16” from left edge
Max. Text Height: 3/8”
Selecting Products
To select a product from the Control Panel by the product number:
1. PRESS the desired Product Group Select Key if that group is not already Selected.
2. Enter a 1 or 2 digit product number using the numeric keypad (the Product Group display clears
and then flashes the new entry).
3. PRESS the Product Group Select Key to enter your new selection.
You may also simply wait 2 seconds and the new selection will be entered automatically without PRESSing
the SELECTED Product Group key. Any component in any Product Group can be SELECTED in this manner
(Auto-Enter).
To play multiple pairs of speakers in the same Product Group:
1. Make sure the desired speaker Product Group is SELECTED (LED ON).
2. Enter 1 or 2 digit number of speaker pair you wish to add and LPRESS Product Group key.
The SELECTED speaker’s Product Group window will alternately display the two speaker pair numbers.
You may add more speaker pairs in the same manner (depending on system limitations set during installa-
tion), but remember that you could be presenting a severe load (low impedance) to the amp’s output, so be
careful. Check the receiver or amplifier manufacturer’s recommendations for maximum number of speakers.
To deselect one of the speaker pairs playing in the same Product Group:
1. Enter the 1 or 2 digit number of the pair you wish to deselect, and
2. PRESS the corresponding Product Group key or simply wait for Auto-Enter.
Note:
The maximum number of speakers that can play at the same time is determined by DIP Switch
settings on the 980 System Module Board. If you cannot select multiple speakers to play simultaneously,
please refer to the Installation Manual’s instructions on setting the 980 System Module or call the factory at
800-322-8346.