Accu-Chek Mobile User Manual - page 179

179

Checking the meter 7

3 

Twist the cap off the applicator. Be careful not to 

squeeze the applicator too hard while doing this so 

as to not lose any control solution. 

4 

Hold the applicator at a slight angle with the brush 

pointing downwards.

5 

Squeeze the applicator gently until you see a small 

drop appear at the end of the brush.

6 

Then stop squeezing.

The drop will then be absorbed back into the brush. 

The brush is now ready to use.

you can hold the meter in your hand or lay it down 

while you apply control solution to the test area.

 do not hold the meter with the test area pointing 

upwards. If you hold the meter with the test area 

pointing upwards, control solution could enter 

the meter and soil it.