Ultralight 2 ( u l - 2 ) o w n e r ’ s m a n u a l.
To remove / replace bulb note: only mr-16 type bulbs should be used with the ul2. 1. Pull out on the thumb tabs of the head module. 2. Swing hood open. 3. Remove and replace bulb as necessary. 4. Close head module, insuring that it “clicks” closed. Thumb tabs hood to re-attach head module push head ...
Introduction the ultralight 2 (ul2) is an extremely compact, super lightweight version of the original ultralight system, designed specifically for on-camera lighting applications. The ultralight 2 incorporates many unique features including: • included with a ab-60, wide angle bulb. • a diffused gl...
5/64 hex wrench shoe sleeve shoe mount thumbwheel set screw be sure the shoe sleeve is completely inside the light, otherwise the light may swing back & forth. ¼-20 stud mount application the ultralight 2 is shipped standard with ¼-20 stud mount for attaching to the camera handle. To remove/install ...
Stud mount application 1/4-20 screw accessories ul2 wedge the ul2 wedge is developed specifically for use with the anton/bauer ultralight 2 on-camera light. The ul2 wedge provides the ultralight 2 with an additional 20º of down angle lighting for shooting extreme close up camera shots (less than 3 f...
When properly fitted, the slot in the tab will align with a screw in the center of the hood. The tab insertion requires a slight force. If the filter assembly is too loose and does not stay in place, bend each side of the tab in opposite directions as shown to provide sufficient holding friction. Th...
Ul-soft box the ul-soft box mounts easily to any ultralight head module to soften and diffuse light output. The ul-soft box is collapsible allowing easy storage or can fold and swing away while remaining on the ultralight until needed. Ultradaylight the ultradaylight head module fits any ultralight ...
Bulb selection and operation bulbs used by the ultralight 2 are type mr16, tungsten-halogen bulbs. Spot or flood bulbs of any light distribution angle may be used. The ultralight 2 offers the greatest versatility with the following low voltage bulbs. They can be powered from any 12-14.4 volt camera ...
Warranty important: warranty registration card must be mailed within 10 days of purchase to qualify for this warranty. Proper registration will also enable us to send you important update information. We must have the warranty registration card on file at our customer service department to establish...
The worldwide standard the following are registered trademarks of anton/bauer, inc.: acs, anton/bauer, anton/bauer logo, automatique, compac, gold mount,hytron, impac, interactive, interactive 2000 logo, lifesaver, logic series,logic series logo, powerstrap, propac, ssp, satellight, snap on,the worl...
