Powercharger dual 2722 charger / power supply owner’s manual.
Table of contents introduction…………………………………………………………………....1 features…………………………………………………………………………..1 safeguards………………………………………………………………………2 grounding/earthing………………………………………………………....2 operation…………………………………………………………………………3 charging.......................................................................
Introduction the dual 2722 is a simultaneous 2 position interactive 2000 powercharger fast charger with 70 watt dc camera power supply. It incorporates all of the logic series circuits that are employed in every anton/bauer charger. The interactive charge programming provides all charge termination ...
Safeguards power sources: this unit was designed to operate at mains voltages from 90 to 264 volts ac, 50-60 hz. Risk of electrical shock: refer servicing to qualified service personnel. To prevent fire or shock hazard, do not expose this unit to rain or moisture. Grounding/earthing important warnin...
Charging as with all anton/bauer chargers, charging with dual 2722 is fully automatic. Mount any digital logic series or logic series battery to the dual 2722 and it will automatically determine the appropriate charge routine and execute it. Applications the dual 2722 will charge any anton/bauer log...
Three stage charging methodology in general, the dual 2722 will deliver a three stage charge routine to each battery. 1. Stage one will deliver a high rate charge matched to the capabilities of the battery (typically a one or two hour rate, depending on battery type). During this stage, six separate...
Led indications the dual 2722 has two sets of two leds (one red, one green) and one green status led in the center. The green status led indicates: steady green – line voltage is present; off – line voltage not present.. The red and green charge status led’s indicate the charging status of the batte...
1 - - - - - - - 2 - - - - - - - lcd indications each powercharger’s liquid crystal display (lcd) will display the status of each battery, as well as, important powercharger operating indications. The following information explains the indications which appear in the lcd. The levels of the lcd displa...
Ddm (diagnostic/discharge module) a standard feature with the dual 2722, the ddm completes a battery management system, capable of testing battery capacity and identifying battery anomalies before they appear in the field. The ddm will perform a standard or a 24 hour test. The standard test is a ful...
To operate the ddm 1. Mount the battery to any position on the powercharger. When the powercharger has completed its communication with the battery, the alternating red and green leds will stop and the battery will begin its charge routine. The battery information and position number will appear on ...
“autocal” feature when a ddm is installed in the powercharger, a special interactive mode is automatically enabled for digital batteries placed on the powercharger at any time. The powercharger will interrogate the status of the digital battery to determine whether the battery has received a “learni...
Operation as dc camera supply from mains the dual 2722 can operate cameras and camcorders using the four pin camera output connector located on the back of the dual 2722. To power the camera, attach one end of the xlr4 accessory cable (available separately) to the dual 2722. Attach the other end to ...
Fcc notice this equipment has been tested and found to comply with the limits for a class a digital device pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This eq...
Warranty important: please mail warranty registration card within ten (10) days of purchase. We must have this card on file with our customer support group to establish this warranty. Proper registration will also enable us to provide update information on the battery system. All new anton/bauer pro...
