Titan ™ t2 charger / power supply owner’s manual.
Table of contents introduction .......................................................................................... 1 features .................................................................................................... 1 safeguards ........................................................
1 introduction the titan t2 is a simultaneous 2 position interactive fast charger with 70 watt dc camera power supply. It incorporates all of the logic series circuits that are employed in every anton/bauer charger. The interactive charge programming provides all charge termination and protection ro...
2 safeguards power sources: this unit was designed to operate at mains voltages from 90 to 250 volts ac, 50-60 hz. Risk of electrical shock: refer servicing to qualified service personnel. To prevent fire or shock hazard, do not expose this unit to rain or moisture. Grounding/earthing important warn...
3 charging as with all anton/bauer chargers, charging with titan t2 is fully automatic. Mount any digital logic series or logic series battery to the titan t2 and it will automatically determine the appropriate charge routine and execute it. Applications the titan t2 will charge any anton/bauer logi...
4 three stage charging methodology in general, the titan t2 will deliver a three stage charge routine to each battery. 1. Stage one will deliver a high rate charge matched to the capabilities of the battery (typically a one or two hour rate, depending on battery type). During this stage, six separat...
5 note: batteries may be kept on a charger until ready for use. The lifesaver mode will keep them 100% charged. Led indications the titan t2 has two sets of three leds (one red, two green). The green status led indicates: steady green – line voltage is present with no power drawn through camera outp...
6 operation as dc camera supply from mains the titan t2 will automatically operate as a dc power supply once power is drawn from the 4 pin xlr, for example, when the camera, or other device is turned on. There are no switches, it is fully automatic. The green status led will flash indicating that th...
7 fcc notice this equipment has been tested and found to comply with the limits for a class a digital device pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This ...
8 warranty important: please mail warranty registration card within ten (10) days of purchase. We must have this card on file with our customer support group to establish this warranty. Proper registration will also enable us to provide update information on the battery system. All new anton/bauer p...
7595-0187 rev a one or more of the following patents may apply: 4,810,204 4,822,296 4,965,738 5,057,383 other patents, u.S. And international may apply or are pending. The worldwide standard ® the following are registered trademarks of anton/bauer, inc.: acs, anton/bauer, anton/bauer logo, automatiq...
