Stasis tm flex owner’s manual ® a7595-0326 rev a da-c078 sht 1 of 16.
A7595-0326 rev a da-c078 sht 2 of 16.
Table of contents introduction.............................................................................. 1 setting up your stasisflex ................................................. 2 start with stand alone stasisflex ................................. 2 to use stasisflex with gold mount..........
Introduction the anton/bauer stasisflex is a versatile handheld support assist device that can be used alone or as a power support with anton/bauer gold mount or elipz batteries. The unique patent pending locking flex arm allows a camera to be instantly adjusted to a variety of shooting positions an...
Setting up your stasisflex start with the stand alone stasisflex yattach camera to mounting platform (figure 1) using ¼-20 mounting screw. (place and attach cushion pads included in package to allow camera to fully tighten to platform). Tip: a standard quick release system such as the manfrotto 3299...
To use stasisflex with gold mount requires one of the adapter plates below (see catalog for information): y fgm-s gold mount with dc-dc converter for 6 volt to camera – 14 volt to powertap connector. With cable and camera connector for sony cameras y fgm-p gold mount with dc-dc converter for 6 volt ...
To mount gold mount adapter plate to stasisflex (1) attach gold mount adapter to back of stasisflex using hardware supplied with adapter (remove cardboard backing plate before attaching). If you are intending to attach wireless microphone receivers to the camera the universal bp (see anton/bauer cat...
To use stasisflex with elipz battery system requires: y elipz extension cable – extends standard elipz camera cable for back mounting of elipz – powers camera and elightz with native 7.2v. Y connector support (included with extension cable) (figure c) y spare elipz mounting shoe (optional) to back m...
Operating stasisflex operation of the stasisflex is intuitive and easily handled. After following the appropriate set up routine above, follow the tips below for adjusting stasisflex to fit you and your shooting style. Y adjusting to your shoulder: carefully bend the adjustable chest pad arm (figure...
Y adjusting the position of the camera: while supporting camera, (as in picture on page 2) open locking lever (figure 5). The flexible arm will release completely when latch is open. It is best to release locking lever only when the camera is on the stasis flex, on your shoulder and your hand is sec...
Tension adjustment collar: the flex arm holding tension should be adjusted for the weight of the camera. Lighter cameras will require less tension to lock into place. Conversely, heavier cameras will require more tension. Rotating the tension adjustment collar (figure 4) increases the clamping force...
Precautions read and follow all instructions for this device and any device with which it will be used. Y always hold camera securely when releasing or locking arm latch. Y be sure that the flex arm locking mechanism is securely latched. Caution: inadvertent operation of the latching mechanism of th...
Y it is recommended that the camera and any accessory – e.G. Battery, wireless receiver, light – be removed from the stasisflex when transporting or relocating. Y maximum operating load for stasisflex is 14 lbs (6.4 kg) with 7 lbs (3.2 kg) maximum at camera mounting plate and 7 lbs (3.2 kg) at backp...
Limited warranty this six (6) month limited warranty for the product specified in this document (“product”) is given by anton/bauer, inc. (“anton/bauer”), 14 progress drive, shelton, connecticut 06484. If you (the purchaser of the product from anton/bauer, or the person for whom the product was purc...
Anton/bauer be responsible for any special, incidental or consequential damages. This warranty is to be construed and enforced in accordance with the law of the state of connecticut, including the provisions of the uniform commercial code as adopted and from time to time amended in the state of conn...
The power behind the best cameras capturing the best images in the world. Sm the following are trademarks of anton/bauer, inc.: acs, adm, anton/bauer, anton/bauer logo and parallelogram design, aspekt, automatique, datatap, dionic, egripz, elightz, elipz, essentialz, gold mount, hytron, impac, inter...
