B-AMP Bergantino Owner's Manual - page 11
10
switch. (See Mem1/Mem2 Save on how to save settings to this location). Push this knob
again, and you will be taken back to the previous home screen.
12. Mem2/HMID Control: This control has multiple functions:
As a Tone Control, turning the control Left or Right from the home screen will decrease or
increase the level of the High-Mid frequencies in 1dB increments, from -9db to +9db. The level
in dB will be shown above on the LCD display.
Push and hold this control for 2 seconds, and you will be able to adjust the center frequencies
of all 4 tone controls. The frequency range of the HMID control is from 800Hz to 3kHz, variable
in 100Hz increments. You can return to the home screen by pressing any of the tone controls,
or if left idle for 5 seconds, the LCD display will return to the home screen automatically.
If a tone setting has been previously stored in this location, when quickly pushed and released,
that tone setting will be loaded into the DSP’s tone filters, including the state of the bright
switch. (See Mem1/Mem2 Save on how to save settings to this location). Push this knob
again, and you will be taken back to the previous home screen.
13. Bright/TRBL Control: This control has multiple functions:
As a Tone Control, turning the control Left or Right from the home screen will decrease or
increase the level of the Treble frequencies in 1dB increments, from -9db to +9db. The level in
dB will be shown above on the LCD display.
If you push and hold this control for 2 seconds, you will be able to adjust the center
frequencies of all 4 tone controls. The frequency range of the TRBL control is from 3kHz to
9kHz, variable in 500Hz increments. You can return to the home screen by pressing any of the
tone controls, or if left idle for 5 seconds, the LCD display will return to the home screen
automatically.
When this control is quickly pressed and released, it activates the Bright filter. Use this control
to add some sparkle or snap to your final tonal contour. (See Bright Adjust Menu in Program
Mode on how to program the frequency and gain of this filter)
14. Prog (Program Button): From the Home Screen, press and hold the Prog button for 3
seconds to enter Program Mode. The green Prog LED will illuminate (See Program Mode).
Orwhile pressing and holding the Prog button, press Mem1 or Mem2 to save a tone setting in
that location (See Mem1/Mem2 Save in Extended Amplifier Features).
15. Mute: When Mute is engaged, the red Mute LED will illuminate and the amplifier’s Main
output, DI output, and Line output (except when tuner is selected for the Line out) will be
muted.
If the B|AMP’s tuner is disabled (see Tuner section in Program Mode), the following screen
will be shown on the LCD display.