B-AMP Bergantino Owner's Manual - page 16
15
Pre-EQ ó Post- EQ
Pre-EQ: This signal includes input gain and effects loop, but no tone controls
Post-EQ: This signal includes input gain, effects loop and tone controls.
ð
The B
|
AMP’s Profile EQ section will never go to the DI
output, thus never to the FOH
system. This is an important feature of the B
|
AMP’s architecture, as it allows the
profiles to properly EQ your stage system without interfering with the FOH system.
Your Post EQ DI contains only your tone adjustments, not your speaker EQ!
Screen 3 – Bright Filter Adjust Menu
This menu allows you to adjust the center frequency and gain parameters of the Bright filter.
When the bright function is engaged from the home screen by pushing the Bright control knob,
the parameters you adjust in this menu will be loaded into the DSP’s Bright filter.
ð
Be sure to engage the Bright function while in the Home Screen before entering
program mode so you can test the results of your adjustments in real time while in this
screen.
• Turn the Bass/Filters knob to adjust frequency from 2kHz to 10kHz in
increments of 500Hz.
• Turn the Trbl/Bright knob to adjust gain in increments of 1dB from +3dB
to +12dB.
Below shows the Bright filter adjusted to a center frequency of 4.5khz and a gain of +6db.
Whenever the Bright function is engaged from the home screen, these parameters will be
loaded into the B|AMP’s Bright filter EQ.
Screen 4 – Profile Select
This menu allows you to select one of the B|AMP’s stored speaker Profiles and load it into the
Profile EQ section of the B|AMP’s DSP processor.
Turn the Bass/Filters knob (Left or Right) until the desired Profile appears on the LCD display.
Once displayed, the selected profile will be loaded into the Profile EQ section of the B|AMP’s
DSP
processor. The following screen shows the CN212 profile being selected and loaded into
the B|AMP’s Profile EQ section.