B-AMP Bergantino Owner's Manual - Firmware Upgrade
20
ð
This reset will Not erase any stored Speaker Profiles in the B
|
AMP’s memory, but it
will erase any stored user memory settings in Mem1 and Mem2.
ð
It is Not recommended to do a Factory Reset with a speaker connected to the
B|AMP’s output, as audible pops may be heard.
Screen 13 – Software Rev. Menu
This menu displays the current version of the software loaded into your B
|
AMP.
It will also be displayed upon power up on the welcome screen menus.
Firmware Upgrade
If new software becomes available for your B
|
AMP, you can upgrade the firmware via the USB
port by doing the following:
• Load the firmware *.hex file onto a FAT32 formatted thumb drive.
• Rename the file to bampfw.hex (all lower case)
• With the B
|
AMP’s power off, insert the thumb drive into the USB port
• While holding the Prog button in, turn the B
|
AMP on and continue to hold the Prog
button in until the green Prog led turns on.
• Once the Home Screen appears on the LCD display, remove thumb drive and recycle
power.
• Your new software is ready to go!