Bakers Pride BCO-G Operation Manual - Operating Instructions
GAS CONVECTION OVEN OPERATION MANUAL
10
OPERATING INSTRUCTIONS
Controller Features
Fahrenheit or Celsius Temperature Display
The operator is allowed to configure the controller
to display the temperature in degrees Fahrenheit or
Celsius from the jumper on the back of the circuit board
(J3). By default, the unit is shipped from the factory in
Fahrenheit (J3 not shorted), unless otherwise specified
by the customer. For Celsius display, power unit down,
remove jumper from Pin 1 and short both pins. When
power is re-applied, the controller will be in Celsius
operation.
Programmable Times
The operator will have the ability to program the
cook times for each product key. The controller is
programmable in minutes (up to 59) and seconds (up
to 59), then hours (up to 99).
Programmable Temperatures
The operator will be able to program cook temperatures
for each product key. The valid temperature range is
150 to 550°F (66 to 288°C).
Programmable Hold
The operator will be able to program each product
key for a counting hold time and temperature (140 to
200°F/60 to 94°C) or disable the hold mode.
HOLD LIGHT (LED) ON = hold mode enabled
HOLD LIGHT (LED) OFF = hold mode disabled
Programmable Fan
The operator will be able to program each product key
for one of two fan modes.
FAN LIGHT (LED) ON = Fan always ON
FAN LIGHT (LED) Flashing = Fan pulsed
Flashing Display
The temperature display will flash after every product
key is pressed. The display will continue to flash until
the actual temperature is within 20° of set temperature.