Bakers Pride BCO-G Operation Manual - Operating Instructions
GAS CONVECTION OVEN OPERATION MANUAL
6
OPERATING INSTRUCTIONS
Timed Cooking Rotary Control:
1) Close the oven doors.
2) Turn Selector Switch to “HI” or “LO” position. The
indicator light near the Selector Switch will light.
3) Turn the thermostat knob to the desired cooking
temperature.
4) Upon reaching the set temperature, the indicator
light near the thermostat will go out.
5) Load the oven with product to be cooked.
6) Turn the timer knob to the desired bake time and
timer will start counting down.
7) When timer reaches zero, a buzzer will sound.
8) Turn the timer knob to “O” position.
9) Remove the product from the oven.
Timer is a signal device only and does not control
the oven.
NOTICE
Cook and Hold Rotary Control:
1) Close the oven doors.
2) Turn Selector switch to “HI” or “LO” position. The
indicator light near the Switch will be illuminated.
3) Turn the thermostat knob to the desired cooking
temperature.
4) Upon reaching the set temperature, the indicator
light near the thermostat will go out.
5) Load the oven with product to be cooked.
6) Turn the timer knob to the desired bake time and
timer will start counting down.
7) When timer reaches zero, a buzzer will sound.
8) Turn the timer knob to “O” position.
9) Turn the thermostat knob to the desired hold
temperature.
10) Remove the product from the oven when needed.
Optional Steam Injection: Rotary Control:
The solenoid valve for steam injection is mounted
behind the service panel on the right-hand side of the
unit. The electronic timer is preset at the factory. A 1/4”
copper tubing is provided on the Solenoid Valve for
water hookup with a compression fitting. After the water
hookup is made, make sure that there are no leaks. For
steam injection, press the Steam switch momentarily.
Do not use steam injection at temperatures below
275°F (135°C).
NOTICE
Oven Cool Down Rotary Control:
To cool down the oven to a lower desired temperature,
follow the steps detailed below.
1) Open the oven doors.
2) Turn Selector Switch to “Oven cool down” position.
Fan will now operate and cool down the oven.
3) When the oven has cooled down to the desired
temperature, turn the Selector Switch to “O”
position. Close oven doors.