Bakers Pride BCO-G Operation Manual - Operating Instructions
GAS CONVECTION OVEN OPERATION MANUAL
11
OPERATING INSTRUCTIONS
Programming the Oven Controller
The following steps are needed to enter and program
each of the product keys. Please note that you must
follow each of the steps below for each product key.
The manual “M” key allows you to temporarily
change the set temperature & time and will reset to
the original programming parameters after you are
done cooking. This key is programmed the same
as keys 1, 2 & 3 except that programming mode
does not have to be entered to do it. However, you
can still manually program the controller while in
programming mode.
NOTICE
Action
Result
Press the product key you want to program.
The corresponding LED will light above the
selected product key.
Enter the programming mode by pressing and
holding the area between the START and STOP
keys until the light above the product key starts
flashing (approx. 3 seconds).
You have successfully entered the programming
mode.
To set the cooking time, press the up and down
arrow key to the right of the display.
The longer you press the key, the faster the
display will change.
To set the cooking temperature, press the up and
down arrow key to the right of the temperature
display.
The longer you press the key, the faster the
display will change.
To select the hold feature and set the holding
temperature, press and hold the HOLD key,
then use the up or down arrow to the right of
the temperature display to select your holding
temperature.
This will activate the holding feature and set
the holding temperature. NOTE: The light above
the HOLD key will be on if you have set the hold
feature correctly.
To select the fan operation, press the FAN key
until the mode you want is displayed.
1. The light above the FAN key is on, the fan will
be ON when door is closed.
2. The light above the FAN key is flashing, the fan
will ONLY be ON when the heat goes ON.
To exit the programming mode, press the space
between the START and STOP keys.
The product key light will be on steady, and the
program will be saved.
Portions of this instruction manual pertaining to the CH-100 controller are reprinted
with the permission of Food Automation-Service Techniques, Inc. (Fast).
© 2001 Bakers Pride
Oven Co., Inc. All rights reserved.