Baseline 225 Manual - Switching On The Balancer
12
Carefully check that all the commands on the machine are working properly.
To avoid accidents and injury, the machine must be VHWXS properly, operated correctly and
serviced regularly.
Switching on the balancer
Turn on the machine with the switch on the back of the cabinet (F. pic.4).
After the beep, and the lamp test, the machine is ready to receive the wheel data.
Wheel data input
Press key
。
The machine is ready to receive the WIDTH (the corresponding LED will light)
Measure rim width with the caliper (pic.5)
Change the number shown on the right display using the and keys until the correct
number is set. WIDTH can be input in millimeters or a previous input converted to inches. To
do this press. To return to input in inches hit
again. A LED on the panel will light to
identify the current unit of measurement(mm or inch).
Press again
to confirm the input and to set up the machine for DIAMETER: (the
corresponding LED will light)
Read the rim diameter on tire
Change the number on the right display with the and keys until the correct number is
shown.
DIAMETER can be input in millimeters or a previous input converted to inches. To do this
press. To return to input in inches hit
again. A LED on the panel will light to identify the
current unit of measurement (mm or inch).
Press key
a third time to confirm the input and set up the machine for DISTANCE (the
corresponding LED will light)
Move the distance gauge until it touches the edge of the inside rim channel as shown in pic.6 or
6a according to the different terminal available on the gauge.
Read the machine/rim distance on the ruler
Change the number shown on the right display by pressing the and keys until the
correct setting is shown.
If you hold down the and keys the numbers will spool up or down quickly and make
data input all the more rapid.
Once the wheel data have been input correctly press:
to display the unbalance (recalculated for the new wheel data);
START to do a spin.