Baseline 225 Manual - Other Messages
26
Other messages
CA.1 (GO) First sensivity calibrating spin
CA.2 (GO) Second sensivity calibrating spin
GO Alu Spin with Alu program
GO d15 Spin with motorcycle dynamic program
GO A15 Spin with motorcycle Alu program
GO CTS Spin with CTS programme
St Spin with static balancing program
CCC CCC Unbalance higher than 255 grams.
Using the pedal brake to hold the shaft in
position (Not available on Automatic brake
models)
The pedal brake is only to be used when the machine has stopped and you want to hold the shaft
to add balancing weights on the wheel.
If you have to brake the wheel in an emergency situation while it is been spun by the motor,
first hit to disengage the motor and then use the footpedal.
Balancing accessory availability status
This check permits you to make sure that wear has not alterated the mechanical specifications of
flanges, cones and so on beyond the specified limits.
The test is carried out with a perfectly balanced wheel (to zero without the threshold and showing
the first gram). When this wheel is mounted on the balancer, removed and remounted in a different
position the unbalance weight shown should not be more than 10 grams.
If the unbalance is higher, check all the accessories with care and replace any that show dents,
abnormal wear, bent flanges and so on.
Always remember that if you are using a cone to center the wheel on the shaft, you will never get
good results if the centre hole in the rim is not perfect, i.e. off center or out-of-round. Results are
always better when the wheel is centered with the rim holes.
A last important point: any difference between the way the wheel is mounted on the car and on the
balancing machine will generate some unbalance.
This can only be eliminated with „on vehicle balancing‟ using a finishing balancer to complement
the work of the bench balancer.