Baseline 225 Manual - Opt 1
22
Here the professional experience of the tire specialist comes into play. When you feel that this extra
step could be helpful to reduce road noise to a minimum, select this program.
Press the keys until the OPT program LED lights.
Press
to confirm your choice.
Once you have selected this program the machine will indicate whether it is worthwhile going
through the OPT. To do this the machine will flash the message:
Yes OPT if it is worth the effort
No OPT if it is not.
This decision is made on the basis of the unbalance found with the last spin made (therefore, the last
spin must refer to the wheel on the machine).
You can now ready to move into the first stage of the program and this will be signaled on the
display, if you do not want to continue with this program, press the key.
OPT 1
Mount the rim without the tire on the balancing machine
Turn it until the valve (or hole) is at 12 o‟clock.
Press .
Make the first spin (as instructed by the displays).
At the end of the spin, the program goes into its second stage.
OPT 2
Remove the rim from the balancer
Put the tire on the rim. Put the tire on the balancer
Turn it until the valve is at 12 o‟clock
Press
Make the second spin.
At the end of the spin, the program goes into the 3
rd
stage of the OPT program.
OPT 3
Turn the wheel until the segment in the middle of the screen lights up to indicate the position
Make a chalk mark on the outside wall of the tire at 12 o‟clock
Remove the wheel from the balancer
Turn the tire on the rim until the chalk mark is opposite the valve (i.e.180°)
Remount the wheel until the valve is at 12o‟clock
Press
Make the third spin
At the end of the spin, the program goes into its fourth and last stage.