Bulldog Security RS79P Installation Manual

Other manuals for RS79P: Owner's Manual

Summary of RS79P

  • Page 1

    System features........................................................4 system components..................................................4 required tools...........................................................4 installation check list...............................................4-5 technical...

  • Page 2: System Features

    4 system features ttwo-button wo-button remotely start your vehicle to run the heater or air extended range extended range conditioning from an extended distance. Remote remote ttransmitter ransmitter remote options remote options works with your factory keyless remote transmitter or the transmitter...

  • Page 3: Before You Begin

    5 before you begin if your vehicle has an anti-thef if your vehicle has an anti-theft system, you will need an t system, you will need an additional module, part additional module, part #791. #791. Congratulations, you have purchased one of the most advanced remote starter systems ever made. Your ne...

  • Page 4: Precautions

    6 precautions making connections 1. S 1. Strip back two inches of insulation on the wire from the remote trip back two inches of insulation on the wire from the remote st starter arter.. Ttwo inches of bare wire wo inches of bare wire to operate your test probe, connect the black clip to a good chas...

  • Page 5: Making Connections

    7 6. Use electrical t 6. Use electrical tape to wrap. Be sure to cover the wire ape to wrap. Be sure to cover the wire about two inches on either about two inches on either side of the connection. First pull side of the connection. First pull the wire that you have just connected along the wire that...

  • Page 6: Making Connections

    8 locating & making connections 4. Use electrical t 4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of ape to wrap, be sure to cover about 2 inches on either side of connection. Secure with wire ties as shown. Connection. Secure with wire ties as shown. Wire wire ttie ...

  • Page 7

    9 ignition w ignition wir ire(s) (white) and (white with red stripe) (+12v in run, crank e(s) (white) and (white with red stripe) (+12v in run, crank and sometimes accessory) and sometimes accessory) make all connections as close to the ignition switch as possible make all connections as close to th...

  • Page 8

    10 caution: please check the position of the switch before the wire connection is made. You may cause damage to the control module if the switch is in the incorrect position. The switch is located between the 9-pin harness and the ignition #1 terminal. The switch towards the inside of the control mo...

  • Page 9: Contact De

    11 (parking light output continued) if the circuit is (+) positive and pulls less than 10 amps, connect the brown wire from the 9-pin harness directly to the vehicle’s parking light wire. If the circuit is negative, you must use a relay if not hooking to the bcm or the vehicle’s computer. Part #775 ...

  • Page 10

    12 security security byp bypass output ass output (-) (-) yellow with black stripe yellow with black stripe this yellow with black stripe wire will be used to operate a security bypass module when required. The yellow with black stripe wire will hold a ground output the entire time the remote starte...

  • Page 11: Localisation Et Réalisation

    13 connecting the 9-pin harness 9-pin harness 9-pin harness 7 8 9 6 5 4 3 2 1 important notice: this unit when first powered up must be initialized to code in the remote transmitter. Initialization of the control module: when the unit is first powered up and all the connections are completed with th...

  • Page 12: Neutral Safety Switch

    Mechanical mechanical neutral neutral safety safety switch switch when installing a bulldog remote starter on gm vehicles or dodge dakotas built prior to 1996, you must: use the diagram below to create a circuit that will prevent the use the diagram below to create a circuit that will prevent the re...

  • Page 13: Operator Programming

    15 operator programming adding adding additional additional remotes using remotes using aa working remote working remote press and hold the brake, press and hold button #1 on the working remote for approx. 5 seconds or until the parking lights flash (1) one time, release button #1 on this remote and...

  • Page 14: Localisation Et Réalisation

    16 localisation et rÉalisation des branchements fil(s) d’allumage (blanc et blanc À filet rouge) (+12 v aux positions de marche, de démarrage et parfois d’accessoires) faites tous les branchements le plus près possible du commutateur d’allumage. Le ou les fils d’allumage se trouvent aussi dans le fa...

  • Page 15: Vehicles With Factory

    17 vehicles with factory anti-theft systems manufacturer manufacturer make/ make/ y year ear anti-thef anti-theftt acura tl 99+ transponder cl 98+ transponder rl 99+ transponder integra 00 + transponder nsx transponder audi a4 00+ transponder a6 00+ transponder a8 98+ transponder bmw all 97+ transpo...

  • Page 16: Vehicles With Factory

    Manufacturer make/ year anti-theft 18 rÉalisation des branchements 3.Séparaz le fil du véhicule comme montré ci-dessous. La déparation doit avoit une longueur suffisante pour installer l’autre fil. 2. Dénudez 1 pouce d’isolant du fil sur leguel vous allez faire le brachement. Un pouce de fil nu 6. A...

  • Page 17: Precautions

    19 precautions n'employez pas les raccordements mécaniques de câblage. Pour les fils qui n'ont pas les connecteurs instantanés pré installés de l'usine, les fils doivent êatre reliés en utilisant les illustrations sous la section de fabrication de raccordements de ce guide d'installation. Le manque ...

  • Page 18: Travaux Préliminaires

    20 fcc id: j3stxjs1194 this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. T...

  • Page 19: Operating Functions

    21 a attention ttention: we urge you to immediately place this card in your wallet. Opera operating instructions ting instructions ssttart (with rs82p art (with rs82p remote) remote) press and release button #1 the vehicle will remote start. Ssttart (with factory keyless entry remote) art (with fact...

  • Page 20: Table Des Marières

    Caractéristiques du système.......................................................24 composants du système.............................................................24 outils nécessaires.......................................................................24 etape avant que vous commencer l’insta...