Bulldog Security RS79P Installation Manual - Precautions
6
PRECAUTIONS
MAKING CONNECTIONS
1. S
1. Strip back two inches of insulation on the wire from the remote
trip back two inches of insulation on the wire from the remote st
starter
arter..
TTwo Inches of Bare Wire
wo Inches of Bare Wire
To operate your test probe, connect the
BLACK
clip to a
good chassis ground
. Then
connect the
RED
clip to a
good 12V (+) positive
source. If the test probe is connected
correctly, both the
GREEN
and the
RED
lights will be dimly illuminated. If a
(+) positive
source is probed, the
RED
light will glow bright and the
GREEN
light will go out. If a
(-)
negative
source is probed, the
GREEN
light will glow bright and the
RED
light will go
out.
USING YOUR TEST PROBE
Manufacturer
Manufacturer
Make/
Make/ Y
Year
ear
Anti-thef
Anti-theftt
MALIBU 97+
PASSLOCK 2
MONTE CARLO 96-99
VATS
MONTE CARLO 2000+
PASSLOCK 2
FULL-SIZE PU 98+
PASSLOCK 2
S-10 98+
PASSLOCK 2
SAVANNAH 98+
PASSLOCK 2
SUBURBAN 98+
PASSLOCK 2
TAHOE 98+
PASSLOCK 2
VAN 98+
PASSLOCK 2
VENTURE 99+
TRANSPONDER
CHRYSLER
CONCORD 98+
TRANSPONDER
(GREY KEY ONLY)
LHS 98+
TRANSPONDER
(GREY KEY ONLY)
SEBRING CONV. 98+
TRANSPONDER
(GREY KEY ONLY)
DODGE
300M 99+
TRANSPONDER
(GREY KEY ONLY)
INTREPID 98+
TRANSPONDER
(GREY KEY ONLY)
NEON 2000+
TRANSPONDER
(GREY KEY ONLY)
FORD
CONTOUR 97+
TRANSPONDER
(Some)
CROWN VICTORIA 98+
TRANSPONDER
EXCURSION 2000+
TRANSPONDER
EXPEDITION 97+
TRANSPONDER
EXPLORER 97+
TRANSPONDER
FOCUS 2000+
TRANSPONDER
MUSTANG 98+
TRANSPONDER
F150/250 98+
TRANSPONDER
RANGER 99+
TRANSPONDER
TAURUS 96+
TRANSPONDER
WINDSTAR 2000+
TRANSPONDER
GMC
DENALI 99+
PASSLOCK 2
ENVOY 99+
PASSLOCK 2
S-15 JIMMY 98+
PASSLOCK 2
SAFARI 98+
PASSLOCK 2
VÉHICULES AVEC SYSTÈME
ANTIDÉMARRAGE DE LUSINE
39
!
DO NOT USE
mechanical wiring connections such as a crimp or snap-together taps except
on wires that are pre-installed from the factory. For wires that do not have the snap connectors
pre-installed from the factory, wires must be connected using the illustrations under the Making
Connections section of this manual. Failure to properly connect the wires can result in damage
to your system or your vehicle.
DO NOT
disconnect the battery if the vehicle has an anti-theft-coded radio or is equipped with
an airbag. Doing so may cause a warning light to be displayed and may require a trip to
the dealer to be corrected.
DO NOT
leave the interior or exterior lights on for an extended period of time as it may cause
battery drain. Remove the dome light fuse from the fuse box.
NOTE:
Starter systems do not
work well with a partially discharged battery.
DO NOT
mount the control module until all connections have been made and
tested.
PLEASE USE CAUTION: DO NOT CUT, PROBE OR DISCONNECT THE
VEHICLES AIRBAG WIRES. THESE WIRES WILL ALMOST ALWAYS
BE INSIDE A BRIGHT YELLOW TUBE LOCATED NEAR THE STEERING
COLUMN HARNESS.
WARNING!
On vehicles with air bags or supplemental restraint systems
(SRS) you may notice a bright YELLOW or RED tube with small wires in it
marked SRS underneath the steering column near the key cylinder. DO
NOT tamper or unplug these for any reason to prevent costly damages to
your vehicle or personal injury. Tampering may cause unintended deployment
of the air bags.
If your vehicle is equipped with air bags or a supplemental restraint systems (SRS) and you
CAN NOT identify the air bag wires, STOP THE INSTALLATION IMMEDIATELY and have a
professional identify the air bag wires before continuing the installation.
WARNING! GENERAL MOTORS
REAR WHEEL DRIVE VEHICLES AND DODGE DAKOTAS
All General Motors rear wheel drive vehicles and Dodge Dakotas built prior to 1996 do
not have an electrical Neutral Safety switch. They have a mechanical neutral safety
switch. The mechanical neutral safety switch operates as follows.
a) The key will only turn to start position when the gear selector is in park
or neutral.
b) The key can only be removed from the ignition switch when the gear
selector is in the park position.
You must use special precautions with this system.