Bulldog Security RS79P Installation Manual - Table Des Marières
Caractéristiques du système.......................................................24
Composants du système.............................................................24
Outils nécessaires.......................................................................24
Etape avant que vous commencer linstallation.....................24-25
Assistance technique ..................................................................25
Travaux préliminaires..................................................................25
Précautions............................................................................25-26
Utilisation de la sonde de mesure...............................................26
Réalisation des branchements ..............................................27-28
Localisation et réalisation des branchements........................28-32
Branchement du faisceau à neuf broches ..................................33
Contact de sécurité de point mort ...............................................34
Programmation par lutilisateur ..............................................35-36
Utilisation de lémetteur de télécommande............................36-37
\Identification de la FCC..............................................................37
Fonctions importantes.................................................................37
Tableau des systèmes antidémarrage ...................................38-41
Garantie ......................................................................................42
Protégé par un ou plusieurs des brevets suivants. Autres brevets
en instance.
Brevet n
o
5,942,988 Brevet n
o
6,452,772 Brevet n
o
6,101,428
Brevet n
o
5,677,664 Brevet n
o
5,886,622 Brevet n
o
5,612,670
Brevet n
o
5,459,447
TABLE DES MARIÈRES
23
22
A
ATTENTION
TTENTION:
We urge you to immediately place this card in your wallet.
PROGRAMMING FUNCTIONS
FOR YOUR WALLET OR GLOVE
ADDING
ADDING ADDITIONAL
ADDITIONAL REMOTES USING
REMOTES USING AA WORKING REMOTE
WORKING REMOTE
Press and hold the brake, press and hold Button #1 on the working remote for
approx. 5 seconds or until the parking lights flash (1) one time, release button
#1 and press any button on the NEW remote, the parking lights will flash (3)
three times, the new remote is now programmed.
TTach/T
ach/Tachless Option
achless Option
Press and hold the brake, with the brake held, press and hold button #2 on
the remote for approx. six (6) seconds or until the parking lights flash two (2)
times. Release button #2, press and release button #1, the parking lights will
flash one (1) time. The unit is now programmed for tach mode. Press and
release button #1 again, the parking lights will flash two (2) times. The unit is
now programmed for tachless mode.